![]() ![]() You can probably do this with the rear snow flap and bumper still installed but its not worth the trouble. You can tighten the two rear nuts from the back and the front two through the windows in the track with a long extension on a ratchet. ![]() When you have the last t-bolt in pull the protector back to the edge of the rear heat exchanger. On the first one I just barley put the nuts on and after rocking it and slightly tapping it with a rubber hammer I had a nut fall off thus the reason to install them until the nylon of the locking nut hit the nut. ![]() Push up the 2nd T-bold up you may have to loosen it slightly to get it to go into the t-slots. You need to rock it a little or slightly tap it with a rubber hammer. Pushed up on the T-bolt with a socket and extension to slide it into the T-slot and start pushing the tunnel projector into the tunnel. Actually installed the t-bolts in the tunnel protractors and tightened the nuts on just to the point of hitting the nylon on the locking nut. Installed the tunnel protectors today, The instructions are basically straight forward but I changed them a little. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |